|
Need help
Oct 4, 2015 15:52:28 GMT -5
via mobile
Post by limestone327 on Oct 4, 2015 15:52:28 GMT -5
I have an 88 justy 4wd I installed a new clutch it drove fine for about 10 miles then it was like I throwed it outta gear while I was doing 60 down the road it reved up and quit pulling I was just wondering if anybody had any tips or tricks before I drop the tranny again thanks
|
|
|
Post by certimafied on Oct 4, 2015 20:22:37 GMT -5
I would check that the clutch is adjusted correctly. Next I would check that when you are engaging a gear that you are actually able to engage it fully. Make sure that there is not any slack somewhere in your shifter linkages like a bad rubber bushing or loose bolt or something. Hopefully its just something small, good luck and welcome to the site.
|
|
|
Post by juho on Feb 13, 2016 17:48:08 GMT -5
I had same kind of trouble with my Suzuki Alto. The needle bearing that is between tranny axle and flywheel had broken and got between the clutch and flywheel. That broke my clutch and I had to buy new. Not saying that's your problem, but it sounds like same.
|
|