|
Post by Mato393 on Oct 12, 2014 16:32:55 GMT -5
I have this problem on my both Justys. On actualy used one it was not working when I brouhgt it and yesterday I finaly try to replace the blub, it does not looks burned I replace it but the light is on all the time ingition is on... I hope I am not only one with same problem on two cars I think there could be cuted wire somewhere under carpet. I am not sure where that wire goes and it could bee big problem if it goes around shifter stick because I have this big thing on it:
|
|
|
Post by sp0ngebob on Oct 13, 2014 9:26:30 GMT -5
k your brake fluid. some cars have a fluid level sensor built into the cap. when it gets low enough the hand brake light comes on.
otherwise the sensor for the handbrake, which is exactly like a dome light sensor in the door, needs to be adjusted under the center console.
|
|
|
Post by Mato393 on Oct 13, 2014 11:09:39 GMT -5
So Justy realy got it connected to brake fluid level sensor... I think there is enough fluid, I am gonna try to disconnect that sensor and see what happens...
|
|
|
Post by Mato393 on Oct 13, 2014 11:29:50 GMT -5
There was the problem! I came to car, turn key to OFF position, open the hood than open the brake fluid tank, brake fluid was in half of it and than disconnect the sensor and try it and the light works perfect I checked the wires from sensor it was turned back around the cable so I turn it to normal loocking position and than try it again and everything works perfect now that procedure should helps with this problem One of easyest repair ever
|
|
|
Post by sp0ngebob on Oct 13, 2014 15:38:58 GMT -5
did you add fluid? you need to if thats the issue.
|
|
|
Post by bizarro on Oct 26, 2015 10:30:53 GMT -5
Ya now I'm curious haha
|
|