|
Post by bybeed1 on Nov 29, 2010 17:01:27 GMT -5
Hey guys
I need the measurements for the Rear Lower Control Arm Bushings... mine are shot and really need to be replaced! Does anyone have that info??? Thanks so much!
|
|
|
Post by jmbf10 on May 14, 2012 18:41:12 GMT -5
I was just measuring mine cause mine need replacing too, As best I could measure them, they were 1.5" diameter by 1.5" wide and I think the bolt is a half inch. I'm trying to find a place to get them on the cheap and one possibilty is using a drum sander with the same dimensions: www.caswellplating.com/quicklock-sanding-drum-1-5-x-1-5-x-1-4.htmlhas anyone else tried anything similar?
|
|
dogoman
A Boxer engine will fit in a Justy, its called a WRX
Posts: 445
|
Post by dogoman on May 15, 2012 0:08:44 GMT -5
I just went to the local suspension specialists and they found bushings to match the old ones, and in nolathane too.
|
|
|
Post by henee on Aug 30, 2013 8:39:08 GMT -5
Hey! I'm having gen 1 Subaru Justy, and i need measurements for rear control arm bushings or website where i can order new ones? Are the front control arm bushings same as the back ones?
|
|
|
Post by henee on Sept 2, 2013 5:28:11 GMT -5
Hey! I'm having gen 1 Subaru Justy, and i need measurements for rear control arm bushings or website where i can order new ones? Are the front control arm bushings same as the back ones? Does anyone know? I'll need this information very quick
|
|
|
Post by santaclaw on Sept 18, 2013 14:45:50 GMT -5
|
|