|
Post by FXRseen on Mar 2, 2005 22:28:46 GMT -5
I need to change the Timing Belt and I removed the center bolt from the crank pulley. Now how do I remove the pulley? It won’t come off. The manual describes the pulley as having the center bolt and two other bolts, but they are not there just the center.
Thanks for your input.
|
|
|
Post by Matt on Mar 3, 2005 8:29:24 GMT -5
Muckin' Ruckin' Crank pulley.... pain in the....
Yeah... is the engine still in the car? not alot of room there... it's just a tight fit,.. a large cold chisel between the block and the crank... tap LIGHTLY back and forth on each side... and slowly it will come off... be carefull though the housing for the oil pump is on one side (aluminum) and the water pump the other (same)
Fun
|
|
|
Post by FXRseen on Mar 3, 2005 22:17:43 GMT -5
Yeah it's still in the car. I've sprayed some WD-40 onto it to see if that helps the removial. So from what I know it should just come off now. But you sugest prying it off carfully?
|
|
|
Post by Dubber on Mar 4, 2005 9:11:57 GMT -5
I very carefully pried mine off with a very big (flat) screwdriver. You just have to go easy from one side to the other. It took a few minutes but it finally came off.
|
|