|
engine
Jun 5, 2018 15:47:05 GMT -5
Post by r444janis on Jun 5, 2018 15:47:05 GMT -5
Hello. Can you help me with this screw? how should you get out?
|
|
|
engine
Jun 8, 2018 7:23:01 GMT -5
Post by r444janis on Jun 8, 2018 7:23:01 GMT -5
|
|
|
engine
Jun 13, 2018 2:29:03 GMT -5
via mobile
Post by alex on Jun 13, 2018 2:29:03 GMT -5
Impact Screwdriver. Take your tightest fitting screwdriver and drive it down with a hammer to deepen the flathead recessed area. after add penetrating fluid, heat on the outside (aka torch) and give that impact screwdriver a good hard whack, making sure to hold it down with your free hand the best you can. if it strips mor, in the middle try hammering a large phillips head to fit, rinse and repeat. welcome to being a garage mechanic
|
|