|
Post by Zeke on May 25, 2016 23:12:10 GMT -5
Got an oil leak through the distributor on my ECVT Justy '91 - 1.2L.
Pulled the distributor, replaced the O-ring and put it back in. It used to start fine, but after putting it back in, it just cranks, but no spark. What happen??
I'm stuck at home with one car!!!
|
|
|
Post by Armageddous on May 26, 2016 0:02:23 GMT -5
Which seal did you replace? Just the outside O ring? Nothing should have changed. Make sure the distributor is plugged in, the firing order is right, coil is plugged in etc.
Terry
|
|
|
Post by Zeke on May 26, 2016 0:04:41 GMT -5
Which seal did you replace? Just the outside O ring? Nothing should have changed. Make sure the distributor is plugged in, the firing order is right, coil is plugged in etc. Terry Hi Terry, the inside o-ring on a distributor. Everything is in order, but the timing is maybe off. I'll check in the AM.
|
|
|
Post by Zeke on May 28, 2016 0:35:21 GMT -5
Found the problem. It's distributor rotor!!
|
|
|
Post by Armageddous on May 28, 2016 9:42:45 GMT -5
Nice!!
|
|