|
Post by george on Apr 23, 2016 4:47:06 GMT -5
I have read all the threads but have not seen my problem. The engine starts and runs fine but when I move the gearshit into any postion nothing happens at all. No sounds or noises at all. Have replaced the brushes but no difference. Any suggestions?
|
|
|
Post by nipper on Apr 30, 2016 22:27:12 GMT -5
Does your shifter cable move?
|
|
|
ECVT no go
May 14, 2016 20:56:41 GMT -5
via mobile
Post by george on May 14, 2016 20:56:41 GMT -5
Hi Nipper yes I had checked that the gear shift was operating. I am thinking the electro clutch is not working. What would you think? By the way I am in NZ and own 7 Justys three of them have broken bearings in the ECVT. I buy them for next to nothing. We only have 5 door model's here.
|
|
|
Post by nipper on May 18, 2016 23:50:46 GMT -5
Oh goody send me a clock.
Have you checked for voltage at the brushes, and the brake and gas pedal switches are all aligned properly?
|
|
|
Post by george on Jun 1, 2016 13:23:58 GMT -5
Oh goody send me a clock. Have you checked for voltage at the brushes, and the brake and gas pedal switches are all aligned properly?
|
|
|
Post by george on Jun 1, 2016 13:30:23 GMT -5
Oh goody send me a clock. Have you checked for voltage at the brushes, and the brake and gas pedal switches are all aligned properly? Hi Nipper I had checked the carbon brushes which were OK but some how they got broken. I put them back in carefully and don't understand how they could have broken. Can you give any suggestion? Also a managed to buy a 4volume Subaru service manual which is a huge help. If you send me your email I might send you a clock. George
|
|
|
Post by nipper on Jun 2, 2016 12:09:24 GMT -5
|
|
|
Post by george on Jun 3, 2016 1:45:30 GMT -5
Thanks Nipper that article was helpful. I also found out that when the brushes disintegrated that it burned out the computor as well. Car is running as new now.
|
|
|
Post by nipper on Jun 5, 2016 12:31:34 GMT -5
YAY!
|
|