dogoman
A Boxer engine will fit in a Justy, its called a WRX
Posts: 445
|
timing
Mar 20, 2012 0:05:01 GMT -5
Post by dogoman on Mar 20, 2012 0:05:01 GMT -5
yeah, put it back in, easier to seal the sump, just don't over tighten the bolts.
|
|
|
timing
Mar 22, 2012 3:09:16 GMT -5
Post by nathan1 on Mar 22, 2012 3:09:16 GMT -5
ok well i got everything back together an it idles fine but when i put it in gear an go i can only get up to 40 mph ive tried adjusting the timing belt an distributor what else can i do ? when i set the timing marks to zero i have no throttle response i have to romp on the throttle to get the car to move a couple of feet then stand on the clutch an do the same thing over again i had this problem before i found out i had a blown exhaust valve please help me i need to get my car running so i can use it for work i cant afford to keep paying for gas in my family's rigs
|
|
|
timing
Mar 28, 2012 21:49:19 GMT -5
Post by jgilk1 on Mar 28, 2012 21:49:19 GMT -5
^i have to claim the retarded one as my brother and he is a bit slow at times i think my perents drop kicked him a few times.... hahaha
ok so here is the thing the car starts and runs just fine with no load revs from idle-red line with out hesitation once it is in gear and you give it power (cold) it back fires through the carb and the power dies out... once you finally get the car moving and under power down the road it runs fine but it runs out of balls in second gear @ 40mph and does not pick up any speed past second gear... compression test says 1-2 have 160psi and 3 has 140psi (i don't have a leak down tester to see if the valves are slightly open)
the distributor is turned all the way to the fire wall to achieve just about 0* tdc on a timing light with the green connector connected under the dash... this is with the timing marks lined up like in pictures on page 1...
so with the 17.7* of distributor rotation would putting the cam gear 1 tooth out towards the radiator give me the adjustment to get the timing correct? or should i put 5# of c4 in this stupid thing and blow it sky high???
he stands around and i end up doing all of the work
|
|
|
timing
Mar 28, 2012 22:01:19 GMT -5
Post by nathan1 on Mar 28, 2012 22:01:19 GMT -5
jgilk1 is a retard at times pushing out the pistons out is all of the work he did
|
|