|
Post by ultima on Jan 30, 2009 10:51:51 GMT -5
My inner joint on the driver side is really bad and needs to be replaced, but how do you do that? (maybe pics?)
And also, isn't there any at sale somewhere? Seems like I have to do a trip to my little Trendy at a scrapyard 110km away again :/
|
|
|
Post by ultima on Feb 2, 2009 5:42:25 GMT -5
Maybe it's much easier to just remove the whole drive axle and get another one?
|
|
|
Post by ultima on Feb 3, 2009 18:03:44 GMT -5
Okay. But would it be easier to remove the whole axle with the joints on it, and replace with another?
|
|
SeattleJusty
No, a boxer will not fit in a Justy.
Posts: 1,587
|
Post by SeattleJusty on Feb 4, 2009 10:41:40 GMT -5
Okay. But would it be easier to remove the whole axle with the joints on it, and replace with another? Speaking from experience, yes!
|
|
|
Post by ultima on Feb 6, 2009 17:57:36 GMT -5
Well today I visited a scrapyard (or what you call it) that has a gen1, and I just couldn't find any way to get the damn inner joint of.. Doesn't anyone have pics of this?
Also: - Where is the "roll-pin" located, could it be the thing between the inner joint and tranny? - What is the "inboard control arm bolt"?
|
|
|
Post by ultima on Feb 16, 2009 17:45:38 GMT -5
|
|
|
Post by ultima on Feb 23, 2009 8:59:36 GMT -5
Is it the roll pin at the (blurred) red mark, seen from above?
|
|
|
Post by ultima on Feb 23, 2009 15:32:45 GMT -5
Yaaay! ^^ Now the question is, how do I get it out the best way? I was trying to get it out in a scrapyard car with a screwdriver and hammer, but it didn't move at all
|
|
|
Post by hollandjusty on Feb 23, 2009 15:41:35 GMT -5
You should use a 5mm nail punch?Don't know if that's the correct word.. I mean this useful little tool
|
|