|
Post by haba on Sept 8, 2008 8:33:52 GMT -5
Well, my check engine light is turning on again, but now more often. I've noticed that it usually turns on when i pour some gasoline. It lights for a few minutes than goes off. Sometimes it turns back on while i'm driving. Engine runs completely normal.
Checked error codes. it says:
36 - Igniter circuit 41 - Air/fuel adaptive control
Justy is 1991, 1,2 MPFI, 4WD
Any help?? Thanx
|
|
|
Post by haba on Sept 9, 2008 13:09:45 GMT -5
Tried to reset ECU, connected both connectors, turned on engine, waited.... After a few minutes i got:
32 Oxygen sensor or circuit 33 Vehicle speed sensor (VSS) or circuit 41 Air/fuel adaptive control 43 Throttle switch 62 Electric load signal 63 Blower fan switch
Check engine doesnt go off anymore.
What to do? There's no subaru service near me... and, it's too expensive for me.
|
|
|
Post by Armageddous on Sept 9, 2008 23:54:36 GMT -5
Try leaving your battery disconnected for about 5 minutes, then put the terminal back on. That should reset the computer. -Terry
|
|
|
Post by haba on Sept 10, 2008 8:14:48 GMT -5
did reset... check engine is gone... fuel consumption is really bad, like i have V8 code 41 says Air/fuel adaptive control so i would say i have a bad O2 sensor... will try to replace that
|
|
|
Post by haba on Nov 6, 2008 16:44:44 GMT -5
O2 sensor replacement did the trick No more check engine code, fuel consumption is very good now, much better
|
|
89
got Mud? Ice? Snow?
Posts: 398
|
Post by 89 on Nov 7, 2008 9:14:22 GMT -5
Good morning Haba,
Quick question... Was the removal of the old sensor a piece of cake or a wrasslin' match?
Kanpai,
|
|
|
Post by haba on Nov 7, 2008 21:02:02 GMT -5
well, it took some time to get it out but all you need is patience and some wd-40
|
|
|
Post by streetruler on Nov 8, 2008 18:28:09 GMT -5
i just did this.....i had to take the manifold off and hit it from the backside with penetrating oil. it sucked
|
|