|
Post by garygnu on Oct 17, 2007 19:26:35 GMT -5
I replaced my main bearings, rod bearings, oil pump, water pump timing belt and clutch. I went to start the motor and it just cranks. The timing marks are set correctly and when it cranks the motor has spark and fuel. I checked the recent ECU codes and I get three quick check engine lights with a pause and then three more quick ones (33). The repair manual says it is the vehicals speed sensor. I am at my wits end with this justy. It was running when I got it. Maybe, I should have drove it with bad rod bearings. Did anyone have this problem or does any one have any ideas??? Everything is pluged it too. Please Help!!!!!! 90 justy Fuel injected 4wd Mattia
|
|
|
Post by Armageddous on Oct 17, 2007 22:29:37 GMT -5
Did you ever have the motor removed? Go over step by step in your mind everything you removed, and everything you installed. It may be a simple connector ... -Terry
|
|
|
Post by garygnu on Oct 28, 2007 22:42:55 GMT -5
I figured out the problem with the motor. It turns out that the fuel lines were reversed. Stupid me. When you remove your fuel lines make sure you label them. I took the car out for a spin and runs great (rod rattle is gone) except for the check engine light. The code is 13, which the repair manual indicates as TDC sensor. Does this mean I need a new distributor?
Thanks Mattia
|
|
|
Post by henri on Oct 29, 2007 16:24:12 GMT -5
|
|