|
Feb 9, 2004 14:43:14 GMT -5
Post by Justy4x4 on Feb 9, 2004 14:43:14 GMT -5
What you need is a new distributor shaft seal. If I can find the part number, I'll post it. You'll need to disassemble the distributer to change it. The only hard part about the whole job is getting the pin pressed out of the end of the shaft, the one that holds the drive dog in place.
|
|
|
Feb 9, 2004 18:53:00 GMT -5
Post by Justyracer on Feb 9, 2004 18:53:00 GMT -5
If you go to a subaru dealer it shoudl not be to expensiv ?
or you can trye to find a O ring that fit in a autoparts shop ?
O...BTW...topic like this should be in the wanted section...
i dont really care..but...
|
|