|
Post by maltajusty on Dec 14, 2004 23:53:53 GMT -5
Hi all, As you know my Justy is equipped with a 998 Carbed engine. Now I wish to fit extra gauges like Oil Pressure, Oil Temperature gauge. These should fit with no problem as all I need to do is remove the original pressure gauge from the block, fit a T-adapter and bolt everything back.
Now the problem comes with the water temperature gauge. I don't wish to drill a hole in the manifold, does anyone know if there are already pre-drilled holes?
Thanks Ray
|
|
|
Post by Matt on Dec 15, 2004 13:17:19 GMT -5
Not sure on that block... but there is a pre-drilled and plugged port for a block heater on the "back" of the 1.2L perhaps you could drill and tap that...
|
|