|
Post by justyleague on Oct 23, 2016 19:13:38 GMT -5
Ok here's the deal, 89 Justy GL fwd 2dr w/ECVT Carb'd died on me in my drive way the other day... Was about to pull away and I didnt even switch into gear just idling and died & couldnt nor have I restarted it since. Its not getting spark, I took the coil in to AutoZone and had them "test" it with a multimeter and guy said it fails both primary and secondary resistance checks. I oredered a new ignition coil UF-38 and still wont start. I need some one to take a picture of there coil and the hook ups and igniter. Because there is 4 wires from a harness that go into a plug that goes into a little black box(IGNITER?) then 2 wires come out of the box and plug into the coil. I had pulled the 4 wires outta the plug harness for testing and didnt make note of they're original position. So please if ya'll could do that for me I'd really appreciate it! Also Autozone told me the igniter usually goes out with the coil and in some of my searching I read this guy talk about bypassing his igniter and kind of hard wiring to the coil with a certain combo of those 4 wires. Please help and all efforts and info are appreciated, Thanks in advance!
|
|
|
Post by dez on Oct 24, 2016 19:26:40 GMT -5
Are you sure your timing belt didn't break?
|
|
|
Post by justyleague on Oct 25, 2016 16:17:58 GMT -5
Yes, i replaced it and the pulley not that long ago and the distributor turns when engines turning over. I just need someone to please take an up close picture of their coil and igniter plug ins so I can match up where what wires go where. Pretty simple, Can nobody do me a solid and stop out to their car pop the hood and pop off a few shots and send them my way? Please...
|
|