justine4wd90: 1990 justy 4wd white for sale in bc canada. $1000. everything works and looks good.
Aug 3, 2015 14:49:46 GMT -5
troll2015: I have no power to my wipers or my horn or my 12v outlets anybody else have this problem
Aug 8, 2015 21:43:03 GMT -5
Mato393: troll do you have good fuses?
Aug 9, 2015 7:34:26 GMT -5
attepaa: i need balanca shaft chain and guide
Aug 9, 2015 13:07:45 GMT -5
Jeremy: 1988 Justy. The cooling fan won't shut off unless relay is pulled.
Aug 10, 2015 14:05:42 GMT -5
deetexe49: looking for a 1988 subaru justy gl 4WD with decent body
Aug 11, 2015 20:11:25 GMT -5
deetexe49: mine runs just needs body.... was rearinded.... damn kids and their phones
Aug 11, 2015 20:26:40 GMT -5
gazaking187: Lower front control arm bushings - Can anyone supply these?
Aug 12, 2015 17:06:47 GMT -5
Mato393: gazaking for rear axle?
Aug 14, 2015 8:15:39 GMT -5
troll2015: mato393 I have checked all the fuzes and they are all good, I think I have a bad ground somewhere
Aug 16, 2015 18:59:16 GMT -5
fresquiti76: Te koop, deze voor zijn leeftijd nette Subaru Justy een heuse ECVT automaat, dus constant variërend koppel én sportstand deze auto rijdt fijner dan een 3traps automaat 1.2 liter met 75pk en op de snelweg rijden is ook geen punt[br]Ik heb er weinig problemen m
Aug 24, 2015 0:58:41 GMT -5
gearheadeh: fresquiti76 It would be best to post your car for sale in the for sale section, this is NOT the place. Also --while this forum welcomes members from all over the world,it is a forum that uses strictly English as the common language that everyone will use
Aug 24, 2015 10:00:31 GMT -5
MrRubburn: Here in malta we dont have motorways or long highways, I hypermile when i can safely and get around 58mpg from my subaru J10 1.0l gl 1994 FWD... I fiddled around with my carb for 2 weeks and finally found the sweet spot for both performance, economy.
Sept 14, 2015 1:59:40 GMT -5
coondog: Does anyone know the thickness or part number to the spacer that sits between the bearings? I tried to make one for my car and I made it 12.4mm and it was too thick, and made the new bearings go bad after a few thousand miles. I have measured it at 11.5mm
Sept 20, 2015 20:33:06 GMT -5
coondog: And plan to get one made this week by a machine shop, but if anyone has a part number ill see if its available to have an oe part instead of something made
Sept 20, 2015 20:34:44 GMT -5